"Include In Database" and "Monitor Changes"

General discussion related to "Everything".
Post Reply
burgundy
Posts: 114
Joined: Fri Oct 16, 2009 9:50 am

"Include In Database" and "Monitor Changes"

Post by burgundy » Thu Nov 15, 2012 12:22 pm

I'm trying to puzzle out what "Monitor Changes" and "Include In Database" do.

Does Everything maintain it's own database (I thought it accessed some internal NTFS index direct)?

Does "Monitor Changes" update Everything's own database such that if "Monitor Changes" is turned off then Everything has to do a scan of the volume each time Everything is launched?

Could someone advise on this please or point me to any threads where this is explained.

Thank you!

therube
Posts: 2355
Joined: Thu Sep 03, 2009 6:48 pm

Re: "Include In Database" and "Monitor Changes"

Post by therube » Thu Nov 15, 2012 8:57 pm

The VOLUMES tab lists all of your drives.

I believe that if INCLUDE were not checked for a particular drive(s), then those drive(s) would not be searched (INCLUDED).

So long as Everything is up & running, MONITOR tracks all changes in real-time.
If you did not MONITOR, then changes would only be reflected ... not sure, on Everything start up?

So you can exclude specific volumes ("drives") by not including them.
And you can also disable real-time update of changes if you wanted.

Everything does have a database, can't quite remember, but might only be written out when you close everything down? It is not that database that is searched, but the MFT.

If Everything is closed down, it is going to rescan on its restart in any case.


See also, http://forum.voidtools.com/viewtopic.php?p=1395#p1395

Post Reply